To measure, place your piece on a flat surface and do not stretch it out.
![crafting dead servers 2.4.4 crafting dead servers 2.4.4](https://i.imgur.com/vhuJfsH.jpg)
That means that you will keep repeating Row 1 (a knit row) and Row 2 (a purl row), in sequence until the piece measures 4” from the cast on row. Rep Rows 1 and 2 until piece measures 4” from the beginning, ending with a WS row. Then for Row 2, the wrong side (WS) of the piece, you will purl every stitch. This means that on Row 1, which is the right side of the piece (RS), you will knit all 12 stitches on the needle. If you are a crocheter, be sure to remember this, as in crochet, the slip knot never counts as a stitch. In knitting, the slip knot always counts as a stitch. That means that you will first make a slip knot on one needle, then cast on 11 more stitches on the same needle. Unless the pattern tells you differently, use the method you were first taught. Some give a nice stretchy edge others give a firm base. Here’s how you make a slip knot (See Figures 1 & 2). Patterns never tell you to do this – they just assume you know it. But wait – before you can start casting on, you must place a slip knot on one of the needles. Special needles are used to work in rounds.įirst the instructions will tell you to cast on a certain number of stitches. Knitted items can be worked back and forth in rows to form a flat piece, or in rounds to form a tube with no seams, such as socks or hats. With the abbreviations and terms at hand, let’s look at a typical knitting pattern.
![crafting dead servers 2.4.4 crafting dead servers 2.4.4](https://static.planetminecraft.com/files/resource_media/screenshot/1648/m06ceqp10696755.png)
When enough new stitches have been added, they should be incorporated into the pattern.Ī complete list of abbreviations used in knitting can be found at Getting Started
![crafting dead servers 2.4.4 crafting dead servers 2.4.4](https://static.planetminecraft.com/files/resource_media/screenshot/1339/2013-09-25_204449_6445068.jpg)
It means that you keep the center part in the pattern as you have already set it up, and will add (or subtract) stitches at each end without disturbing that pattern. This is usually used when you are working a pattern stitch and are increasing (or decreasing) at the edges.